Mazda 6 Service Manual: Valve clearance

Drive belt auto tensioner inspection

1. Remove the drive belt. (See DRIVE BELT REPLACEMENT.) 2. Verify that the drive belt auto tensioner moves smoothly in the operational direction. Replace the drive belt auto tensioner if necess ...

Valve clearance inspection

1. Disconnect the negative battery cable. 2. Remove the tire (RH). 3. Remove the splash shield (RH). 4. Remove the spark plugs. (See SPARK PLUG REMOVAL/INSTALLATION.) 5. Remove the high-tension le ...

Other materials:

Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within the specification, replace the dual proportioning valve. Fluid pressure ...

Mazda 6 Service Manual: Rear upper arm removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...