Mazda 6 Service Manual: Power system

Location index

Exterior lighting system

Other materials:

Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket. 2. Disconnect the DSC HU/CM connector. 3. Connect the SST (49 G066 004) to the DSC HU/CM connector and harness side connector. 4. Inspect voltage referring the table below. Terminal Voltage Table (reference value) (Ignition switch is at ON, and conne ...

Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} onto the solar radiation sensor. Note When incandescent light does not shine on the solar radiatio ...