Mazda 6 Service Manual: Rear beltline molding removal
Note
- When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figure and remove it from the body.
3. Pull the C section upward and remove the clip. Then remove the front beltline molding.
Front beltline molding installation
1. Press the clip into the body.
2. Press in the B section of the front beltline molding along the direction
(1) shown in the figure to attach it to the body.
Note
If the front beltline mold ...
Rear beltline molding installation
1. Press the clip at the C section into the body.
2. Press in the B section of the rear beltline molding along the direction
(1) to attach it to the body.
3. Press the clip at the A section in a ...
Other materials:
Mazda 6 Service Manual: Trunk end trim removal/installation
4SD
1. Remove the fasteners.
2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks.
3. Remove the trunk end trim.
4. Install in the reverse order of removal.
5HB
1. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks.
2. Remove the trunk end tr ...
Mazda 6 Service Manual: No.1 abs warning light, brake system warning light, tcs off light do not
illuminate with ignition switch on
Vehicle with ABS/TCS
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure conn ...