Mazda 6 Service Manual: Rear beltline molding installation
1. Press the clip at the C section into the body.
2. Press in the B section of the rear beltline molding along the direction (1) to attach it to the body.
3. Press the clip at the A section in and attach the rear beltline molding.
Note
- If the rear beltline molding is difficult to attach, apply soapy water.
Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B ...
Roof molding removal
1. Detach the clips which secure A and B sections of roof molding, using a
screwdriver or equivalent tool.
2. While pulling the roof molding up, detach the fit for the T stat of the A
section a ...
Other materials:
Mazda 6 Service Manual: Units
Conversion to SI Units (Système International d'Unités)
All numerical values in this manual are based on SI units. Numbers shown
in conventional units are converted from these values.
Rounding Off
Converted values are rounded off to the same number of places as the SI
unit value ...
Mazda 6 Service Manual: Crankshaft position (ckp) sensor inspection
Note
Perform the following inspection only when directed.
Resistance Inspection
1. Disconnect the CKP sensor connector.
2. Measure the resistance between CKP sensor terminals A and B using an
ohmmeter.
If not as specified, replace the CKP sensor.
If CKP sensor resistance is okay, bu ...