Mazda 6 Service Manual: Rear tilt motor inspection
1. Disconnect the rear tilt motor connector.
2. Inspect the rear tilt motor operation when B+ is applied to the terminals as shown.
- If not as specified, replace the seat cushion frame.
Front tilt motor inspection
1. Disconnect the front tilt motor connector.
2. Inspect the front tilt motor operation when B+ is applied to the terminals
as shown.
If not as specified, replace the seat cushion frame.
...
Slide motor inspection
1. Disconnect the slide motor connector.
2. Inspect the slide motor operation when B+ is applied to the terminals as
shown.
If not as specified, replace the seat cushion frame.
...
Other materials:
Mazda 6 Service Manual: Service cautions
HANDLING INSUFFICIENT REFRIGERANT LEVEL
If an insufficient refrigerant level is detected at troubleshooting,
do not charge (add) the refrigerant. Because an accurate amount of
refrigerant cannot be determined from the pressure indicated on the manifold
gauge, never charge the refrigeran ...
Mazda 6 Service Manual: Oil pump
OIL PUMP REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine oil. (See ENGINE OIL REPLACEMENT.)
3. Remove the oil pan. (See OIL PAN REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Inspect the en ...