Mazda 6 Service Manual: Rearview mirror

Power outside mirror switch inspection

Inspect for continuity between the power outside mirror switch terminals using an ohmmeter. If not as specified, replace the power outside mirror switch. ...

Rearview mirror removal

1. Insert a screwdriver between the mirror and the base. 2. Push the base pin down to remove the rearview mirror. ...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (SUSPENSION) Wheels and Tires Removal/Installation When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Suspension Links Removal/Installation Tighten any part of the suspension that uses rubber bushings only after the vehicle has been lowered ...

Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} onto the solar radiation sensor. Note When incandescent light does not shine on the solar radiatio ...