Mazda 6 Owners Manual: Repairing Damage to the Finish
Deep scratches or chips on the finish should be repaired promptly. Exposed metal quickly rusts and can lead to major repairs.
CAUTION
If your Mazda is damaged and needs metal parts repaired or replaced, make sure the body shop applies anticorrosion materials to all parts, both repaired and new. This will prevent them from rusting.
Exterior Care
The paintwork on your Mazda represents the latest technical developments in composition
and methods of application.
Environmental hazards, however, can harm the paint's protective properties, if
...
Bright-Metal Maintenance
Use tar remover to remove road tar and insects. Never do this with a knife
or similar tool.
To prevent corrosion on brightmetal surfaces, apply wax or chrome preservative
and rub it to a hi ...
Other materials:
Mazda 6 Owners Manual: Headlight bulb removal/installation
Low-beam
Halogen type
1. Disconnect the negative battery cable.
2. Disconnect the front combination light. (See FRONT COMBINATION LIGHT
REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
Caution
A halogen bulb generates extremely high heat when it is used. If
the ...
Mazda 6 Owners Manual: Airflow mode actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal
F or D of the airflow mode actuator.
2. Verify that the airflow mode actuator operates as shown below.
If not as specified, replace the airflow mode actuator.
3. Verify that the resistance between the ter ...