Mazda 6 Owners Manual: Reprogramming the HomeLink system
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. DO NOT
release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, proceed with “Programming” - step 1.
Operating the HomeLink System
Press the programmed HomeLink button to operate a programmed device. The code
will continue being transmitted for a maximum of 20 seconds. ...
Erasing Programmed HomeLink Buttons
To erase the existing programming from all three operating channels, press and
hold the two outside buttons ( ,
) on the auto-dimming mirror until the HomeLink
indicator light begins to flash aft ...
Other materials:
Mazda 6 Owners Manual: Bonnet adjustment
Gap Adjustment
1. Remove the front fender.
2. Loosen the bonnet hinge installation bolts and reposition the bonnet.
3. Tighten the bolts.
4. Verify that the gap between the bonnet and the body is within the
specification.
Clearance
a: 2.5-4.5 mm {0.08-0.17 in}
Height Adjustment
1 ...
Mazda 6 Owners Manual: Oil cooler removal/installation
1. Disconnect the negative battery cable.
2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT.)
3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add ATF to ...