Mazda 6 Service Manual: Special tools

Mazda 6 Service Manual / Special tools

ENGINE

Ford SST numbers are collated with Mazda SST numbers in the example below.

Ford SSTs are marked with Ford SST number.

Example

1: Mazda SST number

2: Ford SST number

LUBRICATION SYSTEM

COOLING SYSTEM

FUEL AND EMISSION CONTROL SYSTEMS

CLUTCH

MANUAL TRANSAXLE

AUTOMATIC TRANSAXLE

FRONT AND REAR AXLE

STEERING SYSTEM

BRAKING SYSTEM

SUSPENSION

BODY

BODY ELECTRICAL SYSTEM

HEATER AND AIR CONDITIONER SYSTEMS

Technical data

ENGINE LUBRICATION SYSTEM Note The maintenance intervals on scheduled maintenance table (See SCHEDULED MAINTENANCE TABLE) can only be supported by the use of following oils. Recomme ...

Other materials:

Mazda 6 Service Manual: Hold switch removal/installation
1. Disconnect the negative battery cable. 2. Remove the console. 3. Disconnect the connector and remove the HOLD switch terminals. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY.) 4. Remove the selector lever knob component. 5. Remove the HOLD switch. 6. Install the HOLD switch to selector lever k ...

Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within the specification, replace the dual proportioning valve. Fluid pressure ...