Mazda 6 Owners Manual: Tire Chains
Check local regulations before using tire chains.
CAUTION
- Chains may affect handling.
- Do not go faster than 50 km/h (30 mph) or the chain manufacturer's recommended limit, whichever is lower.
- Drive carefully and avoid bumps, holes, and sharp turns.
- Avoid locked-wheel braking.
- Do not use chains on a temporary spare tire; it may result in damage to the vehicle and to the tire.
- Do not use chains on roads that are free of snow or ice. The tires and chains could be damaged.
- Chains may scratch or chip aluminum wheels.
NOTE
The tire pressure monitoring system may not function correctly when using tire chains.
Install the chains on the front tires only.
Do not use chains on the rear tires.
Please consult an Authorized Mazda Dealer.
Installing the chains
1. Secure the chains on the front tires as tightly as possible.
Always follow the chain manufacturer's instructions.
2. Retighten the chains after driving 1/2—1 km (1/4—1/2 mile).
Snow Tires
Use snow tires on all four wheels
Do not go faster than 120 km/h (75 mph) while driving with snow tires. Inflate
snow tires 30 kPa (0.3 kgf/cm2, 4.3 psi) more than recommended on the tire pressure ...
Driving In Flooded Area
WARNING
Dry off brakes that have become wet by driving slowly, releasing the accelerator
pedal and lightly applying the brakes several times until the brake performance
returns to normal: Driving ...
Other materials:
Mazda 6 Owners Manual: Instrument cluster removal/installation
Caution
When replacing the instrument cluster, the configuration procedure must be
performed before removing the instrument cluster. If the configuration procedure
is not performed before removing the instrument cluster, it is possible that the
instrument cluster will not operate normally. ...
Mazda 6 Owners Manual: Front fender panel
FRONT FENDER PANEL REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front side turn light.
3. Remove the fender molding. (See COWL GRILLE REMOVAL/INSTALLATION.)
4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
5. Remove the front combination light ...