To temporarily cancel the system, use one of these methods:
Depress the clutch pedal.
If the RESUME/
switch is
pressed when the vehicle speed is 25 km/h (16 mph) or higher, the system reverts
to the previously set speed.
NOTE
The selector lever is in the P or N position.
The shift lever is in the neutral position.
The cruise control cannot be cancelled while driving in manual mode (selector lever shifted from D to M position). Therefore, engine braking will not be applied even if the transaxle is shifted down to a lower gear. If deceleration is required, lower the set speed or depress the brake pedal.
To Resume Cruising Speed at More Than 25 km/h (16 mph)
To DeactivateMazda 6 Owners Manual: Procedures for determining the location of a malfunction
System Wiring Diadram
PCM
1. Check the display of DTC U0121 and/or U0155, using the SST (WDS or
equivalent). (See DTC TABLE.)
2. Referring to the following table, determine the malfunctioning part of the
CAN system.
ABS/TCS HU/CM or DSC HU/CM
1. Accec and monitor the PCM MSG and IC MSGo ...
Mazda 6 Owners Manual: Replacing a Wheel
WARNING
Always use wheels of the correct size on your vehicle: Using a wrong-sized
wheel is dangerous. Braking and handling could be affected, leading to loss of control
and an accident.
CAUTION
A wrong-sized wheel may adversely affect:
Tire fit
Wheel and bearing life
Ground clearance ...