Mazda 6 Service Manual: Vacuum hose routing diagram

Intake-air system

...

Intake-air system removal/installation

Warning When the engine and intake-air system are hot, they can badly burn. Turn off the engine and wait until they are cool before removing the intake-air system. Fuel vapor is hazardous. ...

Other materials:

Mazda 6 Service Manual: Tire house trim removal/installation
4SD 1. Remove the rear scuff plate. 2. Remove the rear seat side. 3. Remove the fastener. 4. Pull the tire house trim upward, then disengage clips A from the body, and remove the tire house trim. 5. Install in the reverse order of removal. 5HB 1. Remove the rear scuff plate. 2. Pull the ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...