Mazda 6 Service Manual: Intake-air system
- Vacuum hose routing diagram
- Intake-air system removal/installation
- Variable air duct (vad) shutter valve inspection (l3)
- Variable air duct (vad) control solenoid valve inspection (l3)
- Variable air duct (vad) check valve (one-way) inspection (l3)
- Idle air control (iac) valve inspection
- Variable intake-air system (vis) shutter valve actuator inspection (l3)
- Variable intake-air system (vis) control solenoid valve inspection (l3)
- Variable tumble control system (vtcs) shutter valve actuator inspection
- Variable tumble control solenoid valve inspection
- Accelerator pedal removal/installation
- Accelerator cable inspection/adjustment
Engine tune-up
IGNITION TIMING INSPECTION
Note
Ignition timing is not adjustable.
Ignition timing verification requires WDS or equivalent.
1. Turn off the electrical loads.
2. Warm up the engine as follow ...
Other materials:
Mazda 6 Service Manual: Floor covering
FRONT FLOOR COVERING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.)
3. Remove the rear seat.
4. Remove the front scuff plates.
5. Remove the rear scuff plates.
6. Remove the console.
7. Remove the front side tri ...
Mazda 6 Service Manual: No.8 brake system warning light stays on more than 4 seconds with ignition
switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure co ...