Mazda 6 manuals

Mazda 6 Service Manual: Accelerator pedal removal/installation

Mazda 6 Service Manual / Fuel and emission control systems / Intake-air system / Accelerator pedal removal/installation

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.



Accelerator Cable Installation Note

Carry out the ACCELERATOR CABLE INSTALLATION/ADJUSTMENT procedure after installing the accelerator cable. (See ACCELERATOR CABLE INSPECTION/ADJUSTMENT.)

Variable tumble control solenoid valve inspection
1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Inspect airflow between the ports under the following conditions. If not as specified, rep ...

Accelerator cable inspection/adjustment
1. Verify that the throttle valve is closed. 2. Pull the accelerator cable in the directions of A and B, and measure the free play. If not as specified, adjust by turning locknut C. Free ...

Other materials:

Mazda 6 Service Manual: TCS/DSC Indicator Light
This indicator light stays on for a few seconds when the ignition is switched ON. If the TCS or DSC is operating, the indicator light flashes. If the light stays on, the TCS, DSC or the brake assist system may have a malfunction and they may not operate correctly. Take your vehicle to an Auth ...

Mazda 6 Service Manual: Changing a Flat Tire
NOTE If the following occurs while driving, it could indicate a flat tire. Steering becomes difficult. The vehicle begins to vibrate excessively. The vehicle pulls in one direction. If you have a flat tire, drive slowly to a level spot that is well off the road and out of the way of tr ...

© 2016-2026 Copyright www.mazda6info.net