Mazda 6 Owners Manual: Battery Maintenance
To get the best service from a battery:
- Keep it securely mounted.
- Keep the top clean and dry.
- Keep terminals and connections clean, tight, and coated with petroleum jelly or terminal grease.
- Rinse off spilled electrolyte immediately with a solution of water and baking soda.
- If the vehicle will not be used for an extended time, disconnect the battery cables and charge the battery every six weeks.
Battery
WARNING
Wash hands after handling the battery and related accessories: Battery
posts, terminals and related accessories contain lead and lead compounds, chemicals
known to the State of California ...
Inspecting Electrolyte Level
A low level of electrolyte fluid will cause the battery to discharge quickly.
Inspect the electrolyte level at least once a week. If it is low, remove the
caps and add enough distilled water to b ...
Other materials:
Mazda 6 Owners Manual: Front fender panel
FRONT FENDER PANEL REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front side turn light.
3. Remove the fender molding. (See COWL GRILLE REMOVAL/INSTALLATION.)
4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
5. Remove the front combination light ...
Mazda 6 Owners Manual: Tire house trim removal/installation
4SD
1. Remove the rear scuff plate.
2. Remove the rear seat side.
3. Remove the fastener.
4. Pull the tire house trim upward, then disengage clips A from the body, and
remove the tire house trim.
5. Install in the reverse order of removal.
5HB
1. Remove the rear scuff plate.
2. Pull the ...