Keyless Entry System/Immobilizer System

Blind Spot Monitoring (BSM) System


NOTE
During printing time of this user manual the approvals listed above are granted.
WARNING
Change or modifications not expressively approved by the party responsible for compliance could void the use's authority to operate the equipment.
HomeLink Wireless Control System
CAUTION
HomeLink has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
NOTE
FCC ID: NZLMOBHL4
CANADA:4112A-MOBHL4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1- This device may not cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
Bluetooth® Hands-Free
Type A
U.S.A. and Canada

FCC ID: CB2MBLUEC09 IC:279B-MBLUEC09
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The term “IC: ” before the radio certification number only signifies that Industry Canada technical specifications were met.
The antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
Mazda Bluetooth® Hands-Free Customer Service
Phone: 800-430-0153 (Toll-free) Web: www.MazdaUSA.com/bluetooth
Mexico

Type B
U.S.A. and Canada

Mexico

Smart Brake Support (SBS)/Mazda Radar Cruise Control (MRCC)/Distance Recognition Support System (DRSS)

Steps for Determining the Correct Load Limit
SpecificationsMazda 6 Owners Manual: Removing a Flat Tire
1. Loosen the lug nuts by turning them counterclockwise one turn each, but do
not remove any lug nuts until the tire has been raised off the ground.
2. Place the jack on the ground.
3. Turn the jack screw in the direction shown in the figure and adjust the jack
head so that it is close to th ...
Mazda 6 Owners Manual: Intermittent concern troubleshooting
Vibration Method
If malfunction occurs or becomes worse while driving on a rough road or
when engine is vibrating, perform the steps below.
Note
There are several reasons why vehicle or engine vibration could
cause an electrical malfunction. Some of the things to check for:
- ...