Mazda 6 Service Manual: Dtc b1602

Dtc b2431

Dtc b1601

Other materials:

Mazda 6 Service Manual: Airflow mode actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the airflow mode actuator. 2. Verify that the airflow mode actuator operates as shown below. If not as specified, replace the airflow mode actuator. 3. Verify that the resistance between the ter ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...