Mazda 6 Service Manual: Dtc p0506

Dtc p0505

Dtc p0507

Other materials:

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Service Manual: Combine sensor removal/installation
Caution Be careful and do not allow the combine sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Remove the center console. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. After installation, perform the comb ...