

Diagnostic procedure


Dtc p0762
Dtc p0766Mazda 6 Service Manual: Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit)
after several seconds of transmission — which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this Canadian law, some U.S.
gate operators are designed to “time-out ...
Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment.
2. Short the A/C check connector to the GND terminal using a jumper wire.
3. Shine a 60 W incandescent light from a height of approximately
100 mm {3.9 in} onto the solar radiation sensor.
Note
When incandescent light does not shine on the solar radiatio ...