Mazda 6 Service Manual: Dtc p0772

Dtc p0771

Dtc p0773

Other materials:

Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2. 2. Set up the WDS (including the vehicle recognition.) 3. Select Module programming. 4. Select Programmable module installation. 5. Select PCM and perform procedures according to directions on the WDS screen. Note If PCM CONFIGURATION is successful, the PCM ...

Mazda 6 Service Manual: Combine sensor inspection
Caution Be careful and do not allow the lateral-G sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Connect the connector. 2. Turn ignition switch on, verify the voltage between terminals B and E under the following conditions. If not within the specifi ...