Mazda 6 Service Manual: Dtc p2503

Dtc p2502

Dtc p2504

Other materials:

Mazda 6 Service Manual: Clock spring inspection
1. Remove the clock spring. 2. Inspect for continuity between the clock spring terminals using an ohmmeter. If not as specified, replace the clock spring. Note When the vehicle-side connector of clock spring is disconnected, the terminals 1A,1B, 1C and 1D are shorted to prevent ...

Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within the specification, replace the dual proportioning valve. Fluid pressure ...