Mazda 6 manuals

Mazda 6 Owners Manual: Keyless Entry System

Mazda 6 Owners Manual / Before Driving / Keys / Keyless Entry System

This system uses the key buttons to remotely lock and unlock the doors and the trunk lid, and opens the trunk lid.

The system can start the engine without having to take the key out of your purse or pocket.

It can also help you signal for attention or help.

Operating the theft-deterrent system is also possible on theft-deterrent systemequipped vehicles.

System malfunctions or warnings are indicated by the following warning lights or beeps.

For vehicles with the type A instrument cluster, check the displayed message for more information and, if necessary, have the vehicle inspected at an Authorized Mazda Dealer, according to the indication.

If you have a problem with the key, consult an Authorized Mazda Dealer.

If your key is lost or stolen, consult an Authorized Mazda Dealer as soon as possible for a replacement and to make the lost or stolen key inoperative.

CAUTION

Radio equipment like this is governed by laws in the United States. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE


Keys
WARNING Do not leave the key in your vehicle with children and keep them in a place where your children will not find or play with them: Leaving children in a vehicle with the key is dangerous. T ...

Transmitter
NOTE (With theft-deterrent system) The hazard warning lights flash when the theft-deterrent system is armed or turned off. Refer to Theft-Deterrent System. (With the advanced keyless fun ...

Other materials:

Mazda 6 Owners Manual: Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission — which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to “time-out ...

Mazda 6 Owners Manual: Roof molding installation
1. Attach the roof molding to the T stud at the A section. 2. Press in the roof molding along the direction (1) shown in the figure and attach it to the clip A at the B section. 3. Hook the roof molding to the clip B at the C section, press it in, and attach the roof molding to the clip B. ...

© 2016-2025 Copyright www.mazda6info.net