Mazda 6 Service Manual: No.5 no temperature control with climate control unit

No.4 air intake mode does not change

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while performing the inspection to discover whether poor contact points are the cause ...

No.6 windshield fogged

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any i ...

Other materials:

Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2. 2. Set up the WDS (including the vehicle recognition.) 3. Select Module programming. 4. Select Programmable module installation. 5. Select PCM and perform procedures according to directions on the WDS screen. Note If PCM CONFIGURATION is successful, the PCM ...

Mazda 6 Service Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament. 2. Attach tape above and below the damaged section of the filament. 3. Using a small brush or marking pen, repair the filament with silver paint or equivalent. 4. After 2-3 minutes, carefully remove the tape without ...