Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / No.9 tcs off light stays on more than 4 seconds with ignition switch on

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harnesses are connected correctly and undamaged.

No.8 brake system warning light stays on more than 4 seconds with ignition switch on

Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact p ...

No.10 tcs does not work correctly

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Hazard Warning Flasher
The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it. Depress the hazard warning flasher and all the turn s ...

Mazda 6 Service Manual: Fuel Gauge
The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full. If the fuel level is low, and turn an amber color. Refuel as soon as possible. Refer to Taking Action. NOTE After refueling, it m ...