Mazda 6 Service Manual: Braking system

Mazda 6 Service Manual / Braking system

Location index

Parking brake system

Abs/tcs

Dynamic stability control

On-board diagnostic (abs/tcs)

On-board diagnostic (dynamic stability control)

Troubleshooting (abs/tcs/dynamic stability control)

System wiring diagram
Precaution
Symptom troubleshooting
No.1 abs warning light, brake system warning light, tcs off light do not illuminate with ignition switch on
No.2 neither abs warning light nor brake system warning lightilluminate with ignition switch on
No.3 abs warning light does not illuminate with ignition switch on
No.4 brake system warning light does not illuminate with ignition switch on
No.5 tcs off light does not illuminate with ignition switch on
No.6 both abs warning light and brake system warning light stay on more than 4 seconds with ignition switch on
No.7 abs warning light stays on more than 4 seconds with ignition switch on
No.8 brake system warning light stays on more than 4 seconds with ignition switch on
No.9 tcs off light stays on more than 4 seconds with ignition switch on
No.10 tcs does not work correctly
No.11 there is malfunction in the system even though abs warning light, brake system warning light, tcs off light do not illuminte
No.1 any of the following lights do not illuminate with ignition switch on: (abs warning light, brake system warning light, dsc indicator light and/or tcs-off light)
No.2 any of the following lights stay on: (abs warning light, brake system warning light, dsc indicator light and/or tcs-off light)
No.3 there is a malfunction in the system even though abs warning light, brake system warning light, dsc indicator light and tcs-off light do not illuminate
No.4 abs or tcs*1 operates frequently/tcs does not work correctly*1: dsc system function contains traction control function, dsc indicator light goes on and off while dsc operates
No.5 dsc*2 operates frequently/dsc does not work correctly*2: dsc indicator light goes on and off while dsc operates

Power steering oil pump disassembly/assembly

Note The following procedure is for replacement of the O-ring and oil seal only. Replace the pump component if other repairs are necessary. 1. Disassemble in the order indicated in the table ...

Location index

...

Other materials:

Mazda 6 Service Manual: To Resume Cruising Speed at More Than 25 km/h (16 mph)
If some other method besides the OFF/ CANCEL switch was used to cancel cruising speed (such as applying the brake pedal) and the system is still activated, the most recent set speed will automatically resume when the RESUME/ switch is pressed. If vehicle speed is below 25 km/h (16 mph), incre ...

Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within the specification, replace the dual proportioning valve. Fluid pressure ...