Mazda 6 Service Manual: Dtc c1119
Diagnostic procedure
Dtc c1095, c1096
Caution
When attaching the tester lead to the ABS (ABS/TCS) HU/CM harnesses
connector the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM
INSPECTION.)
Diagnostic procedure
...
Dtc c1140
Caution
When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness
connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM
INSPECTION.)
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Refrigerant system service procedures
GAS CHARGING SET INSTALLATION
1. Fully close the valves of the SST (49 C061 001).
2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and
low-pressure side joints of the SST (49 C061 001).
3. Connect the SSTs (49 C061 006A, 49 C061 007) to the ends of the
SSTs (49 C061 002, 49 C061 00 ...
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection
Preparation
1. Verify that the battery is fully charged. With the ignition switch on,
verify that the ABS and BRAKE system warning lights goes out after 2.4
seconds.
2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM
detects a failure. Follow the troubles ...