Mazda 6 Service Manual: Dtc c1095, c1096
Caution
- When attaching the tester lead to the ABS (ABS/TCS) HU/CM harnesses connector the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.)
Diagnostic procedure
Dtc b1342
Caution
When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness
connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM
INSPECTION.)
Diagnostic procedure
...
Dtc c1119
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Trunk lid removal/installation
Warning
Removing the stay damper without supporting the trunk lid can be
dangerous. The trunk lid may fall and injure you. Open the trunk lid fully
and support it before removing the stay damper.
1. Disconnect the negative battery cable.
2. Disconnect the trunk lid harness connector, p ...
Mazda 6 Service Manual: Tire house trim removal/installation
4SD
1. Remove the rear scuff plate.
2. Remove the rear seat side.
3. Remove the fastener.
4. Pull the tire house trim upward, then disengage clips A from the body, and
remove the tire house trim.
5. Install in the reverse order of removal.
5HB
1. Remove the rear scuff plate.
2. Pull the ...