Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / No.7 abs warning light stays on more than 4 seconds with ignition switch on

Diagnostic procedure

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harnesses are connected correctly and undamaged.

No.6 both abs warning light and brake system warning light stay on more than 4 seconds with ignition switch on

Diagnostic procedure ...

No.8 brake system warning light stays on more than 4 seconds with ignition switch on

Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact p ...

Other materials:

Mazda 6 Service Manual: To Increase Cruising Speed
Follow either of these procedures. To increase speed using cruise control switch Press the RESUME/ switch and hold it. Your vehicle will accelerate. Release the switch at the desired speed. Press the RESUME/ switch and release it immediately to adjust the preset speed. Multiple operations wil ...

Mazda 6 Service Manual: Electrical parts
Battery cable Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. Wiring Harness To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver. ...