Mazda 6 Service Manual: Fluid level sensor inspection
1. Disconnect the negative battery cable.
2. Disconnect the sensor connector.
3. Inspect for continuity between terminals of fluid level sensor.
- If not as specified, replace the fluid level sensor.
Master cylinder removal/installation
1. Remove in the order indicated in the table.
R.H.D.
L.H.D.
2. Install in the reverse order of removal.
Master Cylinder Installation Note
Caution
Always install the gasket of the power ...
Master cylinder disassembly/assembly
Caution
If the master cylinder body is damaged, replace the unit as a
component. When securing the master cylinder in a vise, tighten only the
flange of the master cylinder.
1. Disassembl ...
Other materials:
Mazda 6 Service Manual: Egr valve inspection
Operation Test
Carry out the EGR Control Inspection. (See EGR Control System
Inspection.
If not as specified, perform the further inspection for the EGR valve.
Resistance Inspection
Note
Perform the following test only when directed.
1. Disconnect the negative battery cable.
2. In ...
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm removal/installation
Caution
When replacing the ABS (ABS/TCS) HU/CM, configuration procedure
must be done before removing the ABS (ABS/TCS) HU/CM. If configuration is
not completed before removing the ABS (ABS/TCS) HU/CM, TCS will not work
properly (with TCS model).
Do not drop the ABS (ABS/TCS) HU/CM. Re ...