Mazda 6 Service Manual: Parking brake system

Disc pad (rear) replacement

1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. ...

Parking brake (lever type) inspection

1. Pull the parking brake lever a few times. 2. Depress the brake pedal a few times. 3. Inspect the parking brake stroke by pulling the parking brake lever with a force of 98 N {10 kgf, 22 lbf}. ...

Other materials:

Mazda 6 Service Manual: Front shock absorber and spring removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-sensor (axle side) and fix it to an appropriate pl ...

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...