Mazda 6 manuals

Mazda 6 Service Manual: No.4 brake system warning light does not illuminate with ignition switch on

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / No.4 brake system warning light does not illuminate with ignition switch on



No.3 abs warning light does not illuminate with ignition switch on
Diagnostic procedure ...

No.5 tcs off light does not illuminate with ignition switch on
Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact p ...

Other materials:

Mazda 6 Service Manual: Opening the Hood
1. With the vehicle parked, pull the release handle to unlock the hood. 2. Insert your hand into the hood opening, slide the latch lever to the right, and lift up the hood. NOTE The lever is located a little to the left of center when facing the vehicle. 3. Grasp the support rod in the pad ...

Mazda 6 Service Manual: Steering gear and linkage removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

© 2016-2024 Copyright www.mazda6info.net