Mazda 6 manuals

Mazda 6 Service Manual: Abs/tcs

Parking brake (lever type) removal/installation
1. Remove the center console. (See CONSOLE REMOVAL/INSTALLATION.) 2. Remove the rear seat cushion (4SD) or rear seat (5HB) . (See REAR SEAT REMOVAL/ INSTALLATION.) 3. Remove the exhaust pipe brac ...

Abs (abs/tcs) hu/cm system inspection
System Inspection Preparation 1. Verify that the battery is fully charged. With the ignition switch on, verify that the ABS and BRAKE system warning lights goes out after 2.4 seconds. 2. If the ...

Other materials:

Mazda 6 Service Manual: Rear wiper arm and blade removal/installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE ADJUSTMENT) Rear Wiper Arm Installation Note Clean the rear wiper arm connector shaft using a wire brush before installing the ...

Mazda 6 Service Manual: Wheel hub, steering knuckle pre-inspection
Wheel Bearing Play Inspection 1. Position a dial indicator against the wheel hub. 2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play. Maximum wheel bearing play 0.05 mm {0.002 in} 3. If the bearing play exceeds the specification, replace and tig ...

© 2016-2026 Copyright www.mazda6info.net