Mazda 6 Service Manual: Windshield wiper arm and blade removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE ADJUSTMENT.)
Windshield Wiper Arm Installation Note
Clean the windshield wiper arm connector shafts using a wire brush before installing the windshield wiper arms.
Windshield wiper motor inspection
L.H.D.
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to terminal E or D and ground to terminal
B, and inspect the operation of the windshield wiper motor ...
Windshield wiper arm and blade adjustment
1. Operate the windshield wiper motor to set the wipers in the park position.
2. Set the windshield wiper arms height as shown.
...
Other materials:
Mazda 6 Service Manual: Rear Cross Traffic Alert (RCTA) (Some models)
The Rear Cross Traffic Alert (RCTA) system is designed to assist the driver in
checking the area to the rear of the vehicle on both sides while the vehicle is
reversing by alerting the driver to the presence of vehicles approaching the rear
of the vehicle.
The Rear Cross Traffic Alert (RCTA) ...
Mazda 6 Service Manual: Drive belt auto tensioner inspection
1. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
2. Verify that the drive belt auto tensioner moves smoothly in the
operational direction.
Replace the drive belt auto tensioner if necessary.
3. Turn the drive belt auto tensioner pulley by hand and verify that it
rotates smoothly ...