Mazda 6 Service Manual: Wiper and washer

Panel light control switch inspection

1. Connect the connector to the panel light control switch. 2. Connect the negative battery cable. 3. Measure the voltage at the panel light control switch using voltmeter. When inspecting termi ...

Windshield wiper motor removal/installation

1. Disconnect the negative battery cable. 2. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.) 3. Remove the cowl grille. (See COWL GRILLE REMOV ...

Other materials:

Mazda 6 Service Manual: Engine tune-up
IGNITION TIMING INSPECTION Note Ignition timing is not adjustable. Ignition timing verification requires WDS or equivalent. 1. Turn off the electrical loads. 2. Warm up the engine as follows. (1) Start the engine. (2) Maintain the engine speed at approx. 3,000 rpm until the cooli ...

Mazda 6 Service Manual: Camshaft position (cmp) sensor inspection
Caution When foreign material such as an iron chip is on the CMP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CMP sensor when replacing. Note Perform the follow ...