Mazda 6 manuals

Mazda 6 Service Manual: Headlight cleaner hose removal/installation

Mazda 6 Service Manual / Body electrical system / Wiper and washer / Headlight cleaner hose removal/installation

1. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Headlight cleaner nozzle adjustment
Use a needle or equivalent to adjust the headlight cleaner nozzle so that the center of fluid properly sprays on the headlight as shown in the figure. HEADLIGHT CLEANER NOZZLE CLEANING Clean the ...

Headlight cleaner switch removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Headlight Cleaner Switch Removal Note 1. Insert your hand f ...

Other materials:

Mazda 6 Service Manual: Ignition switch inspection
1. Disconnect the negative battery cable. 2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 3. Disconnect the ignition switch connectors. 4. Inspect for continuity between the ignition switch terminals using an ohmmeter. If not as specified, replace the ignition switch. ...

Mazda 6 Service Manual: Oil control valve (ocv) inspection
L3 Coil Resistance Inspection 1. Disconnect the negative battery cable. 2. Disconnect the oil control valve connector. 3. Measure the resistance between terminals A and B using an ohmmeter. If not as specified, replace the oil control valve. Specification 6.9-7.9 ohms 4. Connect ...

© 2016-2026 Copyright www.mazda6info.net