Mazda 6 Service Manual: Rear washer nozzle removal/installation
1. Disconnect the negative battery cable.
2. Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION)
3. Remove the rear washer hose from the rear washer nozzle.
4. Compress the tabs of the rear washer nozzle.
5. Pull the rear washer nozzle out to remove it.
6. Install in the reverse order of removal.
7. Adjust the rear washer nozzle. (See REAR WASHER NOZZLE ADJUSTMENT.)
Rear wiper arm and blade adjustment
1. Operate the rear wiper motor to set the wiper in the park position.
2. Set the rear wiper arm onto the ceramics end line.
...
Rear washer nozzle adjustment
Insert a needle or an equivalent tool into the spray hole of the rear washer
nozzle and adjust the nozzle direction as shown.
REAR WASHER NOZZLE CLEANING
Clean the rear washer nozzle. (See WINDS ...
Other materials:
Mazda 6 Service Manual: Battery Recharging
NOTE
Before performing maintenance or recharging the battery, turn off all
accessories and stop the engine.
To disconnect the battery, remove the negative cable first. Install it
last when connecting the battery.
Be sure to remove the caps before recharging the battery.
I ...
Mazda 6 Service Manual: Front stabilizer removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.)
5. Inspect the front wheel alignment. (See FRONT WHEEL A ...