Mazda 6 Service Manual: Rear wiper motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION.)
3. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE ADJUSTMENT.)
Rear washer motor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to the terminal B and ground to the
terminal A of th ...
Rear wiper motor inspection
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
3. Disconnect the rear wiper motor connector.
4. Connect battery positi ...
Other materials:
Mazda 6 Service Manual: Oil cooler removal/installation
1. Disconnect the negative battery cable.
2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT.)
3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add ATF to ...
Mazda 6 Service Manual: Idle air control (iac) valve inspection
Note
Perform the following inspection only when directed.
Operation Test
Carry out the Idle Air Control Inspection. (See Idle Air Control System
Inspection.)
If not as specified, perform the further inspection for the IAC valve.
Resistance Inspection
1. Disconnect the negative batt ...