Mazda 6 manuals

Mazda 6 Service Manual: Rear washer motor removal/installation

Mazda 6 Service Manual / Body electrical system / Wiper and washer / Rear washer motor removal/installation

1. Disconnect the negative battery cable.

2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)

3. Remove in the order indicated in the table.



4. Install in the reverse order of removal.

Windshield washer hose removal/installation
1. Remove the bonnet insulator. 2. Partially peel off the right side mud guard. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. ...

Rear washer motor inspection
1. Disconnect the negative battery cable. 2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION) 3. Connect battery positive voltage to the terminal B and ground to the terminal A of th ...

Other materials:

Mazda 6 Service Manual: Knock sensor inspection
Note Perform the following test only when directed. Resistance Inspection 1. Turn the ignition switch to LOCK. 2. Disconnect the knock sensor connector. 3. Measure the resistance between the knock sensor terminals A and B using an ohmmeter. If not as specified, replace the knock sens ...

Mazda 6 Service Manual: Fuel injector removal/installation
Caution Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it ...

© 2016-2026 Copyright www.mazda6info.net