Mazda 6 Service Manual: Intermittent rear wiper relay removal/installation
5HB
1. Disconnect the negative battery cable.
2. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the ...
Intermittent rear wiper relay inspection
1. Connect the connector to the intermittent rear wiper relay.
2. Connect the negative battery cable.
3. Measure the voltage at the intermittent rear wiper relay using voltmeter.
When inspecting ...
Other materials:
Mazda 6 Service Manual: Call Interrupt
A call can be interrupted to receive an incoming call from a third party.
When is selected or the pickup
button on the steering wheel is pressed, the current call is held and the system
switches to the new incoming call.
When is selected, the current
call is ended and the system switches t ...
Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
Lift off and remove the plug hole plate from the installation areas
(rubber and clips) as shown in the figure.
3. Disconnect the high-tension lead.
4. Remove the spark plugs using the plug-wrench.
5. Install th ...