Mazda 6 manuals

Mazda 6 Service Manual: Windshield wiper motor disassembly/assembly

Mazda 6 Service Manual / Body electrical system / Wiper and washer / Windshield wiper motor disassembly/assembly

1. Disassemble in the order indicated in the table.



2. Assemble in the reverse order of disassembly.

Windshield Wiper Link Removal Note

Pry off the connection between the windshield wiper motor and windshield wiper link.

Windshield wiper motor removal/installation
1. Disconnect the negative battery cable. 2. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION.) 3. Remove the cowl grille. (See COWL GRILLE REMOV ...

Windshield wiper motor inspection
L.H.D. 1. Disconnect the windshield wiper motor connector. 2. Connect battery positive voltage to terminal E or D and ground to terminal B, and inspect the operation of the windshield wiper motor ...

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm removal/installation
Caution When replacing the ABS (ABS/TCS) HU/CM, configuration procedure must be done before removing the ABS (ABS/TCS) HU/CM. If configuration is not completed before removing the ABS (ABS/TCS) HU/CM, TCS will not work properly (with TCS model). Do not drop the ABS (ABS/TCS) HU/CM. Re ...

Mazda 6 Service Manual: Rear lateral link removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

© 2016-2025 Copyright www.mazda6info.net