Mazda 6 Service Manual: Headlight cleaner motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Remove the washer fluid-level sensor. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
Wiper and washer switch inspection
Windshield Wiper And Washer Switch
Without vehicle-speed sensing type wipers
1. Remove the wiper and washer switch. (See WIPER AND WASHER SWITCH
REMOVAL/INSTALLATION)
2. Inspect for continuity be ...
Headlight cleaner motor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to terminal D and ground to terminal C of
the motor. ...
Other materials:
Mazda 6 Service Manual: Three-way catalytic converter (twc) inspection
Note
Make sure that no HO2S DTCs have been detected. If detected, this
inspection is not applicable for TWC inspection.
1. Connect the WDS or equivalent and monitor PIDs as following.
Monitor the right TWC using O2S11 PID for upstream HO2S and O2S12 PID
for downstream HO2S.
2. Be ...
Mazda 6 Service Manual: Speedometer, Odometer, Trip Meter and Trip Meter Selector (Without Multiinformation
Display)
The speedometer indicates the speed of the vehicle.
The display mode can be changed from odometer to trip meter A to trip meter B
and then back to odometer by pressing the selector while one of them is displayed.
The selected mode will be displayed.
Odometer
The odometer records the total d ...