Mazda 6 Service Manual: Windshield washer nozzle cleaning
1. Clean the washer nozzle by inserting and moving a needle or an equivalent tool back and forth.
- If the nozzle becomes clogged again after cleaning, remove the hose from washer nozzle. Make sure there is enough washer fluid. Then turn the washer switch on and flush the inside of the hose.
Windshield washer nozzle removal/installation
1. Remove the bonnet insulator.
2. Remove the windshield washer hose from the windshield washer nozzle.
3. Compress the hooks of the windshield washer nozzle.
4. Pull the windshield washer nozzle o ...
Windshield washer hose removal/installation
1. Remove the bonnet insulator.
2. Partially peel off the right side mud guard.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Variable tumble control solenoid valve inspection
1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the variable tumble control solenoid valve.
If as specified, carry out the Circuit Open/Short ...
Mazda 6 Service Manual: Power steering oil pump disassembly/assembly
Note
The following procedure is for replacement of the O-ring and oil
seal only. Replace the pump component if other repairs are necessary.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Power Steering Oil Pump Component Disassemb ...