Mazda 6 Service Manual: Headlight cleaner nozzle removal/installation
1. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)
2. Disconnect the headlight cleaner hose. (See HEADLIGHT CLEANER HOSE REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the headlight cleaner nozzle. (See HEADLIGHT CLEANER NOZZLE ADJUSTMENT.)
Headlight cleaner motor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to terminal D and ground to terminal C of
the motor. ...
Headlight cleaner nozzle adjustment
Use a needle or equivalent to adjust the headlight cleaner nozzle so that the
center of fluid properly sprays on the headlight as shown in the figure.
HEADLIGHT CLEANER NOZZLE CLEANING
Clean the ...
Other materials:
Mazda 6 Service Manual: Owner Maintenance Precautions
The owner or a qualified service technician should make these vehicle inspections
at the indicated intervals to ensure safe and dependable operation.
Bring any problem to the attention of an Authorized Mazda Dealer or qualified
service technician as soon as possible.
At Least Twice a Year (For ...
Mazda 6 Service Manual: To Resume Cruising Speed at More Than 25 km/h (16 mph)
If some other method besides the OFF/ CANCEL switch was used to cancel cruising
speed (such as applying the brake pedal) and the system is still activated, the
most recent set speed will automatically resume when the RESUME/
switch is pressed.
If vehicle speed is below 25 km/h (16 mph), incre ...