Mazda 6 Service Manual: System wiring diagram

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / System wiring diagram

ABS (ABS/TCS)

DSC

FOREWORD

Before performing the steps in Symptom Troubleshooting, perform the On-board Diagnostic Inspection. To check the DTC, follow the DTC Inspection steps.

Troubleshooting (abs/tcs/dynamic stability control)

...

Precaution

Vehicles with ABS/TCS 1. The ABS warning light, BRAKE system warning light, TCS indicator light and/or TCS OFF light illuminate even when the system is normal. *1 : In cases where the light may ...

Other materials:

Mazda 6 Service Manual: Trunk end trim removal/installation
4SD 1. Remove the fasteners. 2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks. 3. Remove the trunk end trim. 4. Install in the reverse order of removal. 5HB 1. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks. 2. Remove the trunk end tr ...

Mazda 6 Service Manual: Dtc c1148, c1158, c1168, c1178, c1233, c1234, c1235, c1236
Caution When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.) Diagnostic procedure ...