Mazda 6 manuals

Mazda 6 Service Manual: Dtc b2477


Diagnostic procedure


Dtc b1627
Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Dtc c1095, c1096
Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Auto leveling control unit configuration
1. Connect the SST (WDS or equivalent) to the DLC-2. 2. Input vehicle information following the directions on the screen. 3. Select Module programming. 4. Select Programmable module installation. 5. When performing configuration corresponding to each auto leveling control unit, select the fo ...

Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and ...

© 2016-2026 Copyright www.mazda6info.net