Mazda 6 manuals

Mazda 6 Service Manual: Dtc c1119


Diagnostic procedure


Dtc c1095, c1096
Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Dtc c1125
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Intake air temperature (iat) sensor inspection
Resistance Inspection Note Perform the following inspection only when directed. 1. Disconnect MAF/IAT sensor. 2. Measure the resistance between the MAF/IAT sensor terminals D and E using an ohmmeter. If not as specified, replace the MAF/IAT sensor. If the MAF/IAT sensor is okay, but ...

Mazda 6 Service Manual: Front lower arm (rear) removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.) Front Lower Arm (Rear) Ball Joint Removal N ...

© 2016-2026 Copyright www.mazda6info.net