Mazda 6 Service Manual: Dtc c1148, c1158, c1168, c1178, c1233, c1234, c1235, c1236

Mazda 6 Service Manual / Braking system / On-board diagnostic (abs/tcs) / Dtc c1148, c1158, c1168, c1178, c1233, c1234, c1235, c1236

Caution

When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.)

Diagnostic procedure

Dtc c1145, c1155, c1165, c1175

Caution When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.) Diagnostic procedure ...

Dtc c1186, c1266

Caution When attaching the tester lead to the ABS (ABS/TCS) HU/CM harnesses connector the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.) Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2). 5. Pull clip B out, then rotate 45°. 6. Remove clip B from the grommet b ...

Mazda 6 Service Manual: Front door trim removal/installation
1. Disconnect the negative battery cable. 2. Open the cap using a small screwdriver, then remove the screw. 3. Remove the inner handle cover. 4. Remove the inner garnish. 5. Remove the cover, then remove screw A. 6. Remove the lens cover, then remove screw B. 7. Disengage clips A from the ...