Mazda 6 Service Manual: Protection of vehicle
- Always be sure to cover fenders, seats and floor areas before starting work.
Preparation of tools and measuring equipment
Be sure that all necessary tools and measuring equipment are available
before starting any work.
...
Other materials:
Mazda 6 Service Manual: Oil control valve (ocv) removal/installation
L3
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Remove the high-tension lead. (See HIGH-TENSION LEAD
REMOVAL/INSTALLATION.)
4. Remove the oil control valve (OCV) connector.
5. Remove the ventilation hose.
6. Remove the cylinder head cover. (See Cylinder Head Co ...
Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
© 2016-2026 Copyright www.mazda6info.net