Mazda 6 Owners Manual: Rear Window Defogger
The rear window defogger clears fog from the rear window.
The ignition must be switched ON to use the defogger.
Press the switch to turn on the rear window defogger. The rear window defogger operates for about 15 minutes and then turns off automatically.
The indicator light illuminates when the defogger is operating.
To turn off the rear window defogger before the 15 minutes has elapsed, press the switch again.
Manual Climate Control
Fully Automatic Climate Control
CAUTION
Do not use sharp instruments or window cleaners with abrasives to clean the inside of the rear window surface. They may damage the defogger grid inside the window.
NOTE
- This defogger is not designed for melting snow. If there is an accumulation of snow on the rear window, remove it before using the defogger.
- The rear window defogger setting can be changed. After changing the setting, the rear window defogger stops automatically after 15 minutes have elapsed and when the ambient temperature is high. When the ambient temperature is low, it continues to operate until the switch is pressed again.
Windshield Washer
Pull the lever toward you and hold it to spray washer fluid.
NOTE
If the windshield washer is turned on when the windshield wipers are not operating,
the windshield wipers operate a few times.
...
Mirror Defogger (Some models)
The mirror defoggers defrost the outside mirrors.
The mirror defoggers operate in conjunction with the rear window defogger.
To turn on the mirror defoggers, switch the ignition ON and press the rea ...
Other materials:
Mazda 6 Owners Manual: Traction Control System (TCS)
The Traction Control System (TCS) enhances traction and safety by controlling
engine torque and braking. When the TCS detects driving wheel slippage, it lowers
engine torque and operates the brakes to prevent loss of traction.
This means that on a slick surface, the engine adjusts automatically ...
Mazda 6 Owners Manual: Compression pressure
COMPRESSION INSPECTION
Warning
Hot engines and oil can cause severe burns. Be careful not to burn
yourself during removal/installation of each component.
1. Verify that the battery is fully charged.
Recharge it if necessary. (See BATTERY INSPECTION.)
2. Warm up the engine to the no ...