Mazda 6 Service Manual: Trunk lid removal/installation
Warning
- Removing the stay damper without supporting the trunk lid can be dangerous. The trunk lid may fall and injure you. Open the trunk lid fully and support it before removing the stay damper.
1. Disconnect the negative battery cable.
2. Disconnect the trunk lid harness connector, pull the trunk lid harness out from the cabin.
3. Disconnect the hooks, which secure the trunk lid harness to the trunk lid hinge.
4. Pry away the stay damper's band with a screwdriver.
5. Pry out the connecting part of the stay damper and the hinge with a screwdriver to disconnect them. Then remove the stay damper.
6. Remove the nuts, then remove the trunk lid.
7. Remove the bolts, then remove the trunk lid hinge.
8. Install in the reverse order of removal.
9. Adjust the trunk lid. (See TRUNK LID ADJUSTMENT.)
Trunk lid
...
Trunk lid disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the trunk lid trim.
3. To remove the trunk lid outer handle and trunk lid key cylinder, remove
the rear finisher.
4. Disassemble in the order i ...
Other materials:
Mazda 6 Service Manual: Headlight cleaner switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Cleaner Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs
of the headlight cleaner switch.
2. Pull ...
Mazda 6 Service Manual: General procedures
PRECAUTION (BRAKES)
Wheels and Tires Removal/Installation
1. The removal and installation procedures for the wheels and tires are not
mentioned in this section. When a
wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Brake Lines Disconnection/Connection
Cautio ...